![]() ![]() So, take that bottom point up past the top edge a little and fold it over, turning the whole thing over again at the end and firmly crease the fold so it stays in place. It’ll probably be easier if you pick the model up now. The two flaps underneath will pull round a bit that’s fine, just let them come along. ![]() See that point at the bottom? The top layer? You need to bring that up towards the middle of the top edge, so it overlaps a bit.Crease these folds well, then turn the model over. Working with the top layer only, take each of the top corner points and fold the down to meet the bottom point in the middle.Lay this triangle down so the long edge is at the top and go over the creases.You can see that the horizontal crease is going down, while the diagonal ones are popping up just encourage this to happen! The centre should come up in a point while the sides fold in on themselves.With the creases you’ve made, the square should collapse down into a triangle.You’ll be folding the paper in half again, top to bottom then side to side, creasing and opening back up each time.Turn the paper over and position it so it’s square in front of you.Fold in half top to bottom (point to point), crease and unfold then do the same in the other direction, folding one side point to the other then opening up. ![]() Start with the square of paper sat so it looks like a diamond.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |